REPAMERK 301 is a cement based single component, polymer and fiber reinforced, thixotropic structural repair mortar with high strength.
- To repair of the reinforced concrete elements,
- To protect concrete against sulphate and chlorine,
- To repair and protect underground structures,
- Structural and non-structural repairs of high strength concrete elements
- To repair light and medium traffic floors,
- To repair the tie-rod and cone holes.
- Non- shrink.
- Applicable as 10-40 mm thickness at one layer.
- Perfect bonding to the concrete and steel.
- High compressive strength.
- Does not sag due to the thixotropic behavior.
- Waterproof.
- Resistant to chloride, sulphate and oils.
- Easy to apply, mixed with only water.
Content Color Mixing Ratio Mixture Density Adhesion Strength (Concrete) Compressive Strength Flexural Strength Elastic Modulus Capillary Water Absorption Service Temperature Application Temperature Application Tools Pot Life Curing Time Pedestrian Traffic Fully Curing HS Code | Mineral fillers, polymer modified special cement Grey 25 kg REPAMERK 301 : max. 4 L water 2,25±0,1 g/cm3 >2,0 N/mm2 (28 days) (TS EN 1542) >20 N/mm2 (1 day) (TS EN 196) >50 N/mm2 (7 days) >60 N/mm2 (28 days) >7 N/mm2 (28 days) (TS EN 1542) >20000 N/mm2 (28 days) < 0,5 kg/m2.saat0,5(TS EN 13057) -20°C to +400°C +5°C to 30°C Trowel 30 minutes 24 hours 28 days 3214.10.90.00.00 |
Preparation of Substrate
Concrete surface must be sound, clean and dry. Surface must be clean off dust, dirt, rust, oil and all contaminants. If there is a water leakage, it must be drained or properly plugged. Concrete surfaces must be saturated with water before application. Immediately before pouring, surface should be wetted, then remove all excess or standing water from within any formwork.
Application Method
25 kg REPAMERK 301 is poured into maximum 4 liters of water and mix for 3-4 minutes under low speed mixer until having a homogenous consistency. Let the mortar have rest for 4 minutes and re-mix for 30 seconds. Prepared mortar should be applied within 30 minutes in 20°C. REPAMERK 301 is applied on the surface by using a steel trowel or spray gun. Application thickness should be between 10-40 mm. If needed second coat should be applied after 24 hours in same way. If required more smooth finish, water should be sprayed onto the mortar and the surface should be finished with using steel or wooden trowel. Application surface must be protected from the rain, wind, frost etc. during first 24-48 hours after finishing repair.
For 10 mm thickness approximately 19,2 kg/m2 powder is required. Recommended application thickness is min. 10 mm / max. 40 mm.
25 kg kraft bag
12 months in original, unopened package.
Store in dry area between +5°C and +35°C. Protect from heat, freezing and direct sunlight.
Clean tools and equipment with water immediately after use. Dried material can only be removed mechanically.
