MD 150 is mold release agent formulated with aliphatic and natural esters and other performance increase additives to release the concrete from molds in easy way.
For plywoods.
§ Does not penetrate into the concrete and does not leave any scars.
§ Allows to release of concrete easy and smooth from the molds.
§ Protects surface smoothness.
§ Keeps molds clean.
§ Environmental friendly product.
Density Kinematic Viscosity Flash Point Refractive Index (ASTM D 1747) HS Code | 0,80 – 0,90 kg/L 13.7 cSt 185°C 1,485 2710.19.99.00.98 |
Preparation of Substrate
The surface must be clean, dry and free from dust, dirt, rust and grease. Molds should be clean.
Application Method
MD 150 is a ready to use material. It is applied on the molds by dipping, spraying, roller or brush. It should be applied as a thin layer.
20-30 m2area is greased with 1 kg product depends on mold’s surface and type.
30 lt plastic drum
36 months in original, unopened package.
Store in dry area between +5°C and +35°C. Protect from heat, freezing and direct sunlight.
Clean tools and equipment with industrial type solvents immediately after use. Dried material can only be removed mechanically.
- It may be harmful with skin contact.
- Do not apply in freezing conditions or during precipitation.
- Protect applied materials from rain, freezing, foot traffic and continuous high humidity until completely dry.
- Do not use when air and surface temperatures are below +0°C and above +35°C